|
|
 Efficiency is further enhanced with the use of magnetic bearings, which avoid fire friction gaspowerdaircompressors of rubbing parts associated with traditional oiled bearings. Conventional bearings can use as much as 10,000 w, while magnetic bearings require only 180 w. That amounts to 500 times less friction loss. Current development projects are expanding the range and duty of the compressor wheels and promise to offer even greater efficiency for water-cooled and air-cooled duties and different capacities.CONTROLSThe new compressor effectively is a computer. It provides diagnostic and performance information through Modbus to the refrigeration system, which then communicates to the building automation system through Modbus, LonWorks, or BACnet.CHILLER APPLICATIONThe compressor manufacturer and a major chiller manufacturer teamed up to develop a line of ARI-certified water-cooled chillers, which were expected to be introduced in January 2004. The combination of flooded-evaporator technology and an oil-free system has allowed very close approaches and, subsequently, enhanced performance. The integrated gaspowerdaircompressors VFD allows excellent part-load performance as power consumption drops off, depending on the head relief, near the cube root of the shaft speed. Gas cylinders and dewars are becoming relics thanks to the advent of gas-generation systems. These generators turn compressed gas into nitrogen, and deionized water into hydrogen gas. Over the last several years, advances in technology have significantly increased use of these on-site gas generators. Membranes, specialized adsorbents and catalysts, improved air compressors, and enhanced electronic controls have fueled this wave of progress.Gas generators provide consistent, reliable, on-site supplies of gases that are instantly ready for use. And since gaspowerdaircompressors gas generators eliminate the need to gaspowerdaircompressors store gases, they also do away with injuries caused by lifting and dropping heavy metal cylinders. Doing away with cylinders also eliminates the costs of maintenance, shipping, returning, and storing them. There is also no need to keep hydrogen generators away from oxidizing gases or to locate generators in specially constructed areas. The use of permanent magnets instead of rotor windings makes the motor smaller and lighter than induction motors. Using magnetic-bearing technology, a 75-ton gaspowerdaircompressors compressor weighs 265 lb--about one-fifth the weight of a conventional compressor.A variable-speed drive (VSD) is required for the motor to operate. The VSD varies the frequency between 300 and 800 Hz, which provides a compressor-speed range from 18,000 to 48,000 rpm. This avoids a gear set. gaspowerdaircompressors The VSD is integrated into the compressor housing, avoiding long leads and allowing gaspowerdaircompressors key electronic components to be refrigerant-cooled. The VSD also acts as a soft starter; as a result, the compressor has an extremely low startup in-rush current: less than 2 amps, compared with 500 to 600 amps for a traditional gaspowerdaircompressors 75-ton, 460-v screw compressor with a cross-the-line starter. Buy a gas air compressor with us and save a TON of cash. Our selection of cheap gas air compressors is second to none.
|