|
|
 Gas cylinders and dewars are becoming relics gas air compressor parts thanks to the advent of gas-generation systems. these generators turn compressed gas into nitrogen, and deionized water into hydrogen gas. over the last several years, advances in technology have significantly increased use of these on-site gas generators. membranes, air specialized adsorbents and catalysts, improved air compressors, and enhanced electronic controls have fueled this wave of progress.gas generators provide consistent, reliable, on-site supplies of gases that are instantly ready for use. and since gas generators compressor eliminate the need to store gases, parts they also do away with injuries caused by lifting and dropping heavy gas metal air cylinders. doing away with cylinders also eliminates the costs of maintenance, shipping, returning, and storing them. there is also no need to keep hydrogen generators away from oxidizing gases or to locate generators in specially constructed areas. this article describes this new compressor technology and its first use in an ari-certified chiller design.the compressor and parts bearingstraditional centrifugal compressors use roller bearings and hydrodynamic gas bearings, both of which consume power and require oil and a lubrication system. recently, ceramic roller bearings, which avoid issues related to oil and reduce air power consumption, were introduced to the hvac industry. the lubrication of these compressor bearings is provided by the refrigerant itself. (1)magnetic-bearing technology is significantly different. a digitally controlled magnetic-bearing system, consisting of both permanent parts and gas magnets and electromagnets, replaces air conventional lubricated compressor bearings. the frictionless compressor shaft is the parts compressor''s only moving component. it rotates on a levitated magnetic cushion (figure 1). magnetic bearings--two gas radial and one axial--hold the shaft in position (figure 2). the use of permanent magnets instead of rotor windings makes the motor smaller and lighter than induction motors. using magnetic-bearing technology, a 75-ton compressor weighs 265 lb--about one-fifth the weight of a conventional compressor.a variable-speed drive (vsd) is required for the motor to operate. the vsd varies the air frequency between 300 and 800 hz, which provides a compressor-speed range from 18,000 to 48,000 rpm. this avoids a gear set. the vsd is integrated into the compressor housing, avoiding long leads and allowing key electronic components to be refrigerant-cooled. the vsd also acts as a soft starter; as a result, the compressor has an extremely low startup in-rush current: less than 2 amps, compared compressor with 500 to 600 amps parts for a traditional 75-ton, 460-v screw compressor with a cross-the-line starter. Buy a gas air compressor with us and save a TON of cash. Our selection of cheap gas air compressors is second to none.
|