|
|
 Oxygen, water vapor, and other aircompressorgasengine trace gases permeate the membrane fiber and are discharged through a permeate port. Nitrogen stays within the hollow fibers and flows through an outlet port.Balston PSA nitrogen generators produce up to 99.95% pure, compressed nitrogen at dewpoints to -40[degrees]F from nearly any compressed-air supply. The generators continually transform air into nitrogen at safe, regulated pressures without operator attention.PSA generators use a combination of filtration and PSA technologies to create nitrogen.Compressed air is prefiltered aircompressorgasengine to remove all contaminants aircompressorgasengine down to 0.1 micron. The gas separation process preferentially adsorbs oxygen over nitrogen using carbon-molecular sieve (CMS). At high pressures, the CMS has a greater affinity for oxygen, carbon dioxide, and water vapor than it does at low pressures. By raising and lowering pressure within the CMS bed, all contaminants are captured and released, leaving the CMS unchanged. This process lets nitrogen pass through. Depressurizing the CMS releases adsorbed oxygen and other contaminant gases to the atmosphere. Efficiency is further enhanced with the use of magnetic bearings, which avoid fire friction of rubbing parts associated with traditional oiled bearings. Conventional bearings can aircompressorgasengine use as much as 10,000 w, while magnetic bearings require only 180 aircompressorgasengine w. That amounts to 500 times less friction loss. Current development projects are expanding the range and duty of the compressor wheels and promise to offer even greater efficiency for water-cooled and air-cooled duties and different capacities.CONTROLSThe new compressor effectively is a computer. It provides diagnostic and performance information through Modbus to the refrigeration system, which then communicates to the building automation system through Modbus, LonWorks, or BACnet.CHILLER APPLICATIONThe compressor manufacturer and a major chiller manufacturer teamed up to develop a line of ARI-certified water-cooled chillers, which were expected to be introduced in January 2004. The combination of flooded-evaporator technology and an oil-free system has allowed very close approaches and, subsequently, enhanced performance. The integrated VFD allows excellent part-load performance as power consumption drops off, depending on the head relief, near the cube root of the shaft speed. This aircompressorgasengine article describes this new compressor technology and its first use in an ARI-certified chiller design.THE BEARINGSTraditional centrifugal compressors use roller bearings and hydrodynamic bearings, both of which consume power and require oil and a lubrication system. Recently, ceramic roller bearings, which avoid issues related to oil and reduce power consumption, were introduced to the HVAC industry. The lubrication of these bearings is provided by the refrigerant itself. (1)Magnetic-bearing technology is significantly different. A digitally controlled magnetic-bearing system, consisting of both permanent magnets and electromagnets, replaces conventional lubricated bearings. The frictionless compressor shaft is the compressor''s only moving component. It rotates on a levitated magnetic cushion (Figure 1). Magnetic bearings--two radial and one axial--hold the shaft in position (Figure 2). Buy a gas air compressor with us and save a TON of cash. Our selection of cheap gas air compressors is second to none.
|